Rode VideoMic with Rycote Lyre Suspension System

• Directional Video Condenser Microphone
• Rycote Suspension System
• Mounts to Standard Camera Shoe
• 3.5mm Mini Plug
• Studio-Quality Sound
• 9V-Battery-Powered

  The VideoMic with Rycote Lyre Suspension System from Rode is a shotgun microphone that can easily be mounted on a DSLR camera. It features a Rycote suspension system that attaches to the camera's shoe. The VideoMic is lightweight, and when mounted on a camera it does not appear in the frame. The VideoMic can also mount to Rode's boompoles for elevated audio capture. Its supercardioid polar pattern attenuates sounds from the sides. The result is a signal that sounds closer to the camera, even when shooting in noisy environments or at moderate distances.

  The included Rycote Lyre is a non-elasticated suspension structure composed of a hard-wearing thermoplastic. It is more effective at acoustically decoupling microphones from unwanted vibrations, handling and cable-borne noise than elasticated suspensions. The lyre remains effective at a wide range of temperatures and is virtually indestructible. It will never wear out, sag, snap or require any rethreading to maintain its effectiveness.

  An attached, coiled cable terminates to a 1/8" (3.5mm) mini output connection. The VideoMic features a condenser element that utilizes a standard 9V battery (sold separately). The microphone will run for approximately 100 hours on a single battery.

   

  Barrel-Canceling Pickup

  The Rode Video Mic functions as a true line+gradient microphone with a supercardioid pattern in the front and a barrel that cancels side audio. The result is maximum pickup of the source in highly ambient and noisy environments.

  Selectable 10 or 20 dB Pad

  When capturing audio in loud environments, the VideoMic offers built-in attenuation. The selectable 10 or 20 dB pad lessens the microphone's sensitivity, allowing it to handle higher SPL levels without sacrificing clarity.

  High-Pass Filter Switch

  A high-pass filter switch eliminates room ambiance and noise below 80 Hz. This results in improved intelligibility while recording around machinery, wind or close proximities.

  Internal Power

  The condenser element is powered with a standard 9V battery for up to 100 hours (approximately).
  
   

  Rode VideoMic Specs

  Analog Performance
  Operating Principle	Line Gradient
  Transducer	Condenser
  Diaphragm	0.50" / 12.70 mm
  Polar Pattern	Supercardioid
  Frequency Range	40 Hz to 20 kHz
  Equivalent Noise Level	20 dB A-Weighted
  Maximum SPL	134 dB SPL
  Pad	10 dB 20 dB
  THD	1%
  Impedance	200 Ohms
  Sensitivity	-38 dB at 1 kHz
  Low-Cut Filter	@ 80 Hz

  General
  Output Connectors	1 x 1/8" (3.5 mm) TRS
  Battery Type	1 x 9 V
  Operating Voltage	Not specified by manufacturer
  Length	2.56" / 65 mm
  Diameter	4.02" / 102 mm
  Weight	6.21 oz / 176 g

Write a review